You Can Thank Us Later - 9 Reasons To Stop Thinking About Arcade Game
We knew enough to refurbish a good chunk of the games, but we kept hitting the same symptom over and over again. All of our screens would display a scrambled image on the monitor. It was super frustrating because we had no idea how to fix it. We almost missed our launching, but we finally clued in on what was causing our probablem when we discovered about monitor sync 101 and recognized that they sometimes have to be hooked up differently based on the game. On this day, we must have turned at least 20 games, that we had put a lot of hard work into, but had been missing this final piece of this puzzle so as to have the ability to play them. This tiny chunk of understanding, gave us the games we needed to get started and was sufficient to keep us motivated to continue learning how to fix issues.
Five decades later, I still spend more time studying arcade fix, then I spent researching in school and the instruction proceeds to repay.
For the previous couple of years, we've had an average bug that is slipped into our fleet. The games would work great following refurbishment, but three to six months after getting them turned on, they'd all start to fail.
To solve the symptom, we'd boost the power source to operate hot and that would be good for another 3 to six months before the power supplies would burn out. After running into this puzzle a few times, we started to put the matches into deep storage until we can find out why they kept failing. Since we assumed, it was being caused by bad circuit boards hoping to draw too much energy, we missed something a lot more obvious.
After cleaning the chips, it would sometimes help, but this bug was able to throw at 20 of our games. Well todayour Mortal Kombat 2 began to exhibit the same symptoms and quite honestly if we pull that one by the fleet, our clients will riot, so that I sat down to get into the origin of the event of the fall in voltage.
To do this I took my voltage meter, measured the power in the power supply and then began spreading the 5V line and measuring where I could touch wire. When I measured the power before it went into the edge connector, I saw the voltage had dropped. I now suspected the connector between the wire and the power supply. The moment I crimped over the end of the lineup to place on a brand new one, I instantly saw what my issue was.
We love getting a good deal and I'd be happy to bet you a quarter, so which you cannot find a better deal on the jamma harnesses that we purchase. Unfortunately, it seems like we might have gotten what we paid for them.
From the exterior, the tap looks like it uses a thick 18 gauge cable to conduct the power to the board. That is a lot of metal to conduct a small quantity of voltage. It's a part of why I never suspected it was our offender.
As soon as you open it up however, you can see that from the exterior it seems 18 gauge, but on the inside it is short quite a bit of metal. The solution was easy, run a thicker cable in the power supply to the harness and Voila!
While this easy bug ought to have been spotted sooner and has caused us a lot of headaches, it is also incredibly exciting to figure out the origin of our problem and to understand that with very little work, we have another 20 amazing matches back on our site . Learning to correct arcade games has never been simple and your schooling never ends, but each time you solve a puzzle, the following game becoming easier and easier to repair.
Hopefully, other people who have run into similar trouble, can save themselves the same aggravation by A.) double checking the wire you're using when you can not get your voltage to journey directly from the power supply to your circuit boards and B.) paying only slightly better quality jamma harnesses.
